[CT+SPED] OSSC : Open Source Scan Converter Barebones DIY KIT PCB with CLEAR CASE
Open Source Scan Converter is a low-latency video digitizer and scan converter board designed mainly for connecting retro video game consoles and home computers into modern displays. It converts analog RGB/component video into digital format, and doubles (or triples) scanlines of a single frame if necessary to generate a valid mode for digital TVs or monitors.
The board and firmware was designed as a homebrew project mainly during 2015. The primary goal has been to make a scan converter with minimal latency and reasonable cost, which also can be built/assembled manually. Output image quality and features have also been important targets as long as they didn't contradict with primary goals .
Features
Detection and digitization of various analog SDTV/EDTV/HDTV/PC modes
Linedouble-support for 240p, 480i, 288p, 576i, 384p, 480p, 576p
Line3x/4x/5x-support for 240p/288p with different sampling modes
Very low latency (less than 2 input scanlines)
Fast "deinterlace" for 480i/576i and 960i/1080i
Fast recover from input video mode change (e.g. 240p<->480i)
All video processing done in RGB domain - no conversion to YCbCr
Video and sync LPF for less-than optimal input signals
Multiple inputs supporting various formats (see below)
Full-range 24-bit RGB output through DVI/HDMI
Emulated scanlines with configurable strength and position
Configurable mask for overscan area
Selectable sampling configuration for 480p input: DTV-480p or VGA 640x480
Selectable CSC configuration for YPbPr source: Rec. 601 or Rec. 709
PCB WITH CASE ONLY FOR DIY PROJECT. ALL OTHER COMPONENTS MUST BE SOURCED BY THE CUSTOMER. THE CASE IS TRANSPARENT CLEAR AND WILL BE SHIPPED WITH A PROTECTIVE FILM (WHITE).
Full assembly instructions here: https://goo.gl/iAYjtF
The price is 35 EURO without shipping costs, please write your country here for shipping quotes with Registered Mail (about 10-15 EURO).
You can pay with PayPal.